drug induced secondary adrenocortical insufficiency may be minimized by gradual reduction of dosage. this type of relative insufficiency may persist for months after discontinuation of therapy; therefore, in any situation of stress occurring during that period, hormone therapy should be reinstituted. metabolic clearance of corticosteroids is decreased in hypothyroid patients and increased in hyperthyroid patients. changes in thyroid status of the patient may necessitate adjustment in dosage.

e. if damage is present, do not use. step 3 figure c remove the vial from the tray (see figure c). examine the vial and ensure there is no evidence of damage. set aside for use in step 6. step 4 figure d peel off the compartment cover, exposing the sterile tray (see figure d). step 5 figure e grasp and hold the long sides of the tray and invert the tray. squeeze gently to release the sterile tray onto the appropriate sterile preparation surface (see figure e, i – iii ). step 6 vigorously shake the vial for 10 seconds. inspect the vial for clumping or granular appearance of the sterile contents. if clumping or granular appearance is present, do not use. remove the protective plastic cap from the vial and clean the top of the vial with an alcohol wipe. place the vial on a flat surface (see figure f, i – iv ). to avoid settling of the suspension, continue to the next steps without delay. figure f step 7 remove the syringe with attached vial adapter from the tray (see figure g). ensure the vial adapter is secured to the syringe by tightening the connection. figure g step 8 holding the clear barrel of the syringe, connect the vial adapter to the vial by firmly pushing the spike of the vial adapter straight through the center of the vial septum until it snaps securely into place (see figure h). note: do not introduce additional air into the syringe prior to connecting the vial adapter to the vial. figure h step 9 invert the entire assembly so that the vial is directly above the syringe. slide the white plunger handle all the way back and forth multiple times to fill the entire syringe with drug and remove any remaining air (see figure i, i and ii ). note: the syringe should be handled by the clear barrel during filling, connecting and disconnecting procedures. the white plunger handle has a stop to prevent complete removal of the plunger from the syringe. figure i step 10 figure j while holding the vial adapter and vial, disconnect the syringe by twisting it off of the adapter (see figure j). retain the vial, with the vial adapter connected, in the event re-access is necessary. step 11 figure k connect the 900-µm needle to the syringe by twisting onto the syringe (see figure k). at the discretion of the physician, the longer needle may be used. ensure a secure connection. step 12 figure l hold the syringe barrel with the needle pointing up. expel air bubbles and excess drug by slowly sliding the white plunger handle so that the plunger tip aligns with the line that marks 0.1 ml on the syringe (see figure l). note: perform the suprachoroidal injection without delay to prevent settling of the drug. components for administration step 1 step 2 step 3 step 4 step 5 step 6 step 7 step 8 step 9 step 10 step 11 step 12 2.3 administration the suprachoroidal injection procedure should be carried out under controlled aseptic conditions, which include the use of sterile gloves, a sterile drape, a sterile eyelid speculum (or equivalent), and a sterile cotton swab. adequate anesthesia and a broad-spectrum microbicide applied to the periocular skin, eyelid, and ocular surface are recommended to be given prior to the suprachoroidal injection. step 13 figure m identify the injection site by measuring 4 – 4.5 mm posterior to the limbus using the tip of the needle cap or ophthalmic calipers (see figure m). step 14 figure n carefully pull off the needle cap to expose the needle. holding the syringe perpendicular to the ocular surface, insert the needle through the conjunctiva into the sclera (see figure n). step 15 figure o once the needle is inserted into the sclera, ensure that the hub of the needle is in firm contact with the conjunctiva, compressing the sclera and creating a dimple on the ocular surface using a light amount of force against the eye. maintain the dimple and perpendicular positioning throughout the injection procedure (see figure o). step 16 figure p while maintaining the dimple on the ocular surface, gently press the white plunger handle so that the plunger moves forward and drug is slowly injected over 5 – 10 seconds. movement of the plunger will be felt as a loss of resistance and indicates that the needle is in the correct anatomical location for suprachoroidal injection (see figure p). if resistance is felt and the plunger does not advance, confirm the hub is in firm contact with the conjunctiva creating a dimple and that the syringe is positioned perpendicular to the ocular surface. small adjustments in positioning may be necessary. step 17 maintain the hub against the eye for 3 – 5 seconds after the drug product has been injected. step 18 remove the needle slowly from the eye while holding a sterile cotton swab next to the needle as it is withdrawn. immediately cover the injection site with a sterile cotton swab. step 19 hold the swab over the injection site with light pressure for a few seconds and then remove. if continued resistance is experienced during injection attempts: remove the needle from the eye and examine the eye for any issues. if patient safety is not at risk, the physician may use medical judgment to restart the injection procedure at a new site adjacent to the original injection site. if resistance continues and patient safety is not at risk, the physician may use appropriate medical judgment to change to the additional included needle in the sterile tray. twist to remove the needle and reconnect the syringe to the vial by twisting the syringe onto the vial adapter. repeat the preparation and injection process as stated in steps 9 – 18 with the additional needle (allowing for any partial dose given with the first needle when completing preparation step 12). immediately following suprachoroidal injection, patients should be monitored for elevation of intraocular pressure. appropriate monitoring may consist of a check for perfusion of the optic nerve head or tonometry. following suprachoroidal injection, patients should be instructed to report any symptoms suggestive of endophthalmitis or retinal detachment (e.g., eye pain, redness of eye, photophobia, blurring of vision) without delay [see patient counseling information ( 17 )] . each xipere™ package (microinjector syringe with vial adapter, 900-µm needle, 1100-µm needle, and vial of triamcinolone acetonide injectable suspension 40 mg/ml) is single-dose and should only be used for the treatment of one eye. after suprachoroidal injection, all drug product and components (used or unused) must be discarded appropriately. step 13 step 14 step 15 step 16

of patients and non-ocular adverse reactions occurring in ≥ 5% of patients are shown in table 1 . table 1: ocular adverse reactions reported in ≥ 2% of patients and non-ocular adverse reactions reported by ≥ 5% of patients a includes intraocular pressure increased and ocular hypertension b defined as not occurring on the day of the injection procedure, or occurring on the day of the injection procedure and not resolving the same day c includes cataract, cataract cortical, and cataract subcapsular d defined as occurring on the day of the injection procedure and resolving the same day adverse reaction xipere™ (n = 96) n (%) control (n = 64) n (%) ocular increased intraocular pressure, non-acute a, b 13 (14%) 9 (14%) eye pain, non-acute b 11 (12%) 0 cataract c 7 (7%) 4 (6%) increased intraocular pressure, acute a, d 6 (6%) 0 vitreous detachment 5 (5%) 1 (2%) injection site pain 4 (4%) 2 (3%) conjunctival haemorrhage 4 (4%) 2 (3%) visual acuity reduced 4 (4%) 1 (2%) dry eye 3 (3%) 1 (2%) eye pain, acute d 3 (3%) 0 photophobia 3 (3%) 0 vitreous floaters 3 (3%) 0 uveitis 2 (2%) 7 (11%) conjunctival hyperaemia 2 (2%) 2 (3%) punctate keratitis 2 (2%) 1 (2%) conjunctival oedema 2 (2%) 0 meibomianitis 2 (2%) 0 anterior capsule contraction 2 (2%) 0 chalazion 2 (2%) 0 eye irritation 2 (2%) 0 eye pruritus 2 (2%) 0 eyelid ptosis 2 (2%) 0 photopsia 2 (2%) 0 vision blurred 2 (2%) 0 non-ocular headache 5 (5%) 2 (3%)

rature, topical ocular administration of corticosteroids to pregnant mice and rabbits during organogenesis has been shown to produce cleft palate, embryofetal death, herniated abdominal viscera, hypoplastic kidneys and craniofacial malformations. 8.2 lactation risk summary it is not known whether ocular administration of corticosteroids could result in sufficient systemic absorption to produce detectable quantities in human milk. systemically administered corticosteroids appear in human milk and could suppress growth, interfere with endogenous corticosteroid production, or cause other untoward effects. the developmental and health benefits of breastfeeding should be considered along with the mother’s clinical need for xipere™ and any potential adverse effects on the breastfed infant from xipere™. there are no data on the effects of xipere™ on milk production. 8.4 pediatric use safety and effectiveness of xipere™ in pediatric patients have not been established. 8.5 geriatric use no overall differences in safety or effectiveness have been observed between elderly and younger patients following xipere™ administration.

tration of corticosteroids to pregnant mice and rabbits during organogenesis has been shown to produce cleft palate, embryofetal death, herniated abdominal viscera, hypoplastic kidneys and craniofacial malformations.

4 (concentrations ranged from < 10 pg/ml [lloq (lower limit of quantitation) of the assay] to 88.9 pg/ml), with the exception of one patient with a value of 243.4 pg/ml prior to the second dose at week 12.

a ≥ 15-letter improvement in bcva than control patients (p< 0.01) at week 24. bcva mean change from baseline at different visits is shown in figure 1 . central subfield retinal thickness (cst) mean change from baseline at different visits is shown in figure 2 . figure 1: mean change from baseline in bcva figure 2: mean change from baseline in cst figure 1 figure 2